Table 106 Menu 11.6: Remote Node Atm Layer Options; Figure 158 ...................................................................Menu 11.6: Remote Node Atm Layer Options - ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H User Manual

Figure 158 Menu 11.6: Remote Node ATM Layer Options
VC Options for IP:
VPI #= 0
VCI #= 38
ATM QoS Type= UBR
Peak Cell Rate (PCR)= 0
Sustain Cell Rate (SCR)= 0
Maximum Burst Size (MBS)= 0
The following table describes the fields in this menu.

Table 106 Menu 11.6: Remote Node ATM Layer Options

FIELD
VPI
VCI
ATM QoS Type
Peak Cell Rate (PCR) Divide the DSL line rate (bps) by 424 (the size of an ATM cell) to find the Peak
Sustain Cell Rate
(SCR)
Maximum Burst Size
(MBS)
Once you have completed filling in this menu, press [ENTER] at the message "Press ENTER to
Confirm..." to save your configuration and return to menu 11.1, or press [ESC] at any time to cancel.
P-793H User's Guide
Menu 11.6 - Remote Node ATM Layer Options
VPI/VCI (VC-Multiplexing)
Menu 11.6 - Remote Node ATM Layer Options
VPI/VCI (LLC-Multiplexing or PPP-Encapsulation)
VPI #= 0
VCI #= 38
ATM QoS Type= UBR
Peak Cell Rate (PCR)= 0
Sustain Cell Rate (SCR)= 0
Maximum Burst Size (MBS)= 0
DESCRIPTION
The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.
The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local
management of ATM traffic). Enter the VCI assigned to you.
Select CBR (Constant Bit Rate) to specify fixed (always-on) bandwidth for
voice or data traffic. Select UBR (Unspecified Bit Rate) for applications that are
non-time sensitive, such as e-mail. Select VBR (Variable Bit Rate) for bursty
traffic and bandwidth sharing with other applications.
Cell Rate (PCR). This is the maximum rate at which the sender can send cells.
Type the PCR here.
The Sustain Cell Rate (SCR) sets the average cell rate (long-term) that can be
transmitted. Type the SCR, which must be less than the PCR. Note that
system default is 0 cells/sec.
Maximum Burst Size (MBS) refers to the maximum number of cells that can be
sent at the peak rate. Type the MBS, which is less than 65535.
Chapter 26 Remote Node Setup
VC Options for Bridge:
VPI #= 0
VCI #= 38
ATM QoS Type= UBR
Peak Cell Rate (PCR)= 0
Sustain Cell Rate (SCR)= 0
Maximum Burst Size (MBS)= 0
273