Function Group Un-/Locking - Endress+Hauser Proline Prosonic Flow 93C Description Of Device Functions

Device functions Proline Prosonic Flow 93C PROFIBUS DP/PA
Endress+Hauser
5.1.2

Function group UN-/LOCKING

→
USER INTERFACE C
ACCESS CODE All data of the measuring system are protected against inadvertent change. Programming
(2020) is disabled and the settings cannot be changed until a code is entered in this function. If
you press the
function and the prompt to enter the code appears on the display (when programming is
disabled).
You can enable programming by entering your personal code (factory setting = 93, see
DEF.PRIVATE CODE (2021)) .
User input:
Max. 4-digit number: 0 to 9999
!
• The programming levels are disabled if you do not press a key within 60 seconds
• You can also disable programming in this function by entering any number (other than
• The Endress+Hauser service organization can be of assistance if you mislay your
DEF. PRIVATE CODE Use this function to specify a personal code number for enabling programming in the
(2021) ACCESS CODE function.
User input:
0 to 9999 (max. 4-digit number)
Factory setting:
93
!
• Programming is always enabled with the code "0".
• Programming has to be enabled before this code can be changed. When programming
STATUS ACCESS Use this function to check the access status for the function matrix.
(2022)
Display:
ACCESS CUSTOMER (parameterization possible)
LOCKED (parameterization disabled)
ACCESS CODE The number of times the private or service code was entered to access the device appears
COUNTER on the display.
(2023)
Display:
Integer (delivery status: 0)
CONTROL
Functional description
USER INTERFACE → CONTROL → UN-/LOCKING
OS
keys in any function, the measuring system automatically goes to this
Note!
following automatic return to the HOME position.
the defined private code).
personal code.
Note!
is disabled this function is not available, thus preventing others from accessing your
personal code.
5 Block USER INTERFACE
→
CAA BASIC CONFIGURATION 200
↓
UN-/LOCKING 202
23