Endress+Hauser Proline Prosonic Flow 93C Description Of Device Functions page 112

9 Block SUPERVISION
112
VALUE SIMULATION
!
MEASURAND
The function is not visible unless the function SIMULATION MEASURAND (8043) is
(8044)
active.
Use this function to specify a selectable value (e.g. 12 m
associated functions in the device itself and downstream signal loops.
User input:
5-digit floating-point number, [unit]
Factory setting:
0 [unit]
"
• The setting is not saved in the event of a power failure.
• The appropriate unit is taken from the SYSTEM UNITS (ACA) function group,
SYSTEM RESET Use this function to perform a reset of the measuring system.
(8046)
Options:
NO
RESTART SYSTEM (restart without interrupting power supply)
MEASURING TUBE DATA (restore the original calibration data)
!
The T-DAT must be present in order to successfully restore the original calibration data
when the MEASURING TUBE DATA option is selected. If it is not, the error message
K-CAL T-DAT (# 043) appears on the display. For further information, see PROline
Prosonic Flow 93C PROFIBUS, BA089D
Factory setting:
MEASURING TUBE DATA
OPERATION HOURS The hours of operation of the device appear on the display.
(8048)
Display:
Depends on the number of hours of operation elapsed:
Hours of operation < 10 hours
Hours of operation 10 to 10,000 hours
Hours of operation > 10,000 hours
Device functions Proline Prosonic Flow 93C PROFIBUS DP/PA
Functional description
SUPERVISION → SYSTEM [CH2] → OPERATION
Note!
Caution!
( → Page 13).
Note!
→
display format = 00:00:00 (hr:min:sec)
→
3
/s). This is used to test the
→
display format = 0000:00 (hr:min)
display format = 000000 (hr)
Endress+Hauser