Table of Contents
Advertisement
Figure 37 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Global Setup
The following table describes the labels in this screen.
Table 19 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Global Setup
LABEL
IPv6 Hop Limit
ICMPv6 Rate Limit
Bucket Size
ICMPv6 Rate Limit
Error Interval
Apply
Cancel
Clear
8.8.4 IPv6 Interface Setup
Use this screen to turn on or off an IPv6 interface and enable stateless autoconfiguration on it. Click the
link next to IPv6 Interface Setup in the IPv6 Configuration screen to display the screen as shown next.
Figure 38 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Interface Setup
Chapter 8 Basic Setting
DESCRIPTION
Specify the maximum number of hops (from 1 to 255) in router advertisements. This is the
maximum number of hops on which an IPv6 packet is allowed to transmit before it is
discarded by an IPv6 router, which is similar to the TTL field in IPv4.
Specify the maximum number of ICMPv6 error messages (from 1 to 200) which are allowed
to transmit in a given time interval. If the bucket is full, subsequent error messages are
suppressed.
Specify the time period (from 0 to 2147483647 milliseconds) during which ICMPv6 error
messages of up to the bucket size can be transmitted. 0 means no limit.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the nonvolatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to reset the fields to the factory defaults.
MES3500-24S/MGS3520 Series User's Guide
92
Advertisement
Table of Contents
Troubleshooting
