Pppoe Ia For Vlan - ZyXEL Communications XMG1930 Series User Manual

The following table describes the labels in this screen.
Table 117 Advanced Application > PPPoE > Intermediate Agent > Port > VLAN
LABEL
Show Port
Show VLAN
Start VID
End VID
Apply
Port
VID
*
Circuit-id
Remote-id
Apply
Cancel

29.3.3 PPPoE IA for VLAN

Use this screen to set whether the PPPoE Intermediate Agent is enabled on a VLAN and whether the
Switch appends the Circuit ID and/or Remote ID to PPPoE discovery packets from a specific VLAN.
Click the VLAN link in the Intermediate Agent screen to display the screen as shown.
Figure 169 Advanced Application > PPPoE > Intermediate Agent > VLAN
Chapter 29 PPPoE
DESCRIPTION
Enter a port number to show the PPPoE Intermediate Agent settings for the specified VLANs on
the port.
Use this section to specify the VLANs you want to configure in the section below.
Enter the lowest VLAN ID you want to configure in the section below.
Enter the highest VLAN ID you want to configure in the section below.
Click Apply to display the specified range of VLANs in the section below.
This field displays the port number specified above.
This field displays the VLAN ID of each VLAN in the range specified above. If you configure the *
VLAN, the settings are applied to all VLANs.
Use this row to make the setting the same for all VLANs. Use this row first and then make
adjustments on a VLAN-by-VLAN basis.
Changes in this row are copied to all the VLANs as soon as you make them.
Enter a string of up to 63 single-byte printable characters that the Switch adds into the Agent
Circuit ID sub-option for this VLAN on the specified port. Spaces are allowed.
The Circuit ID you configure here has the highest priority.
Enter a string of up to 63 single-byte printable characters that the Switch adds into the Agent
Remote ID sub-option for this VLAN on the specified port. Spaces are allowed.
If you do not specify a string here or in the Remote-id field for a specific port, the Switch
automatically uses the PPPoE client's MAC address.
The Remote ID you configure here has the highest priority.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XMG1930 Series User's Guide
245