Multiple Spanning Tree Protocol Status - ZyXEL Communications XMG1930 Series User Manual

Table 70 Advanced Application > Spanning Tree Protocol > MSTP > Port (continued)
LABEL
Edge
Apply
Cancel

13.7 Multiple Spanning Tree Protocol Status

Click Advanced Application > Spanning Tree Protocol in the navigation panel to display the status
screen as shown next.
Note: This screen is only available after you activate MSTP on the Switch.
Figure 112 Advanced Application > Spanning Tree Protocol > Status: MSTP
Chapter 13 Spanning Tree Protocol
DESCRIPTION
Select this check box to configure a port as an edge port when it is directly attached to a
computer. An edge port changes its initial STP port state from blocking state to forwarding
state immediately without going through listening and learning states right after the port is
configured as an edge port or when its link status changes.
Note: An edge port becomes a non-edge port as soon as it receives a Bridge
Protocol Data Unit (BPDU).
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XMG1930 Series User's Guide
157