Table of Contents
Advertisement
Configuring the HP Processor Probe for PowerPC 603/603e
General Configuration Items
Setting BNC Break In operation
The cf breakin command selects the operation of the Break In BNC on the
front of the HP processor probe for connection to a logic analyzer.
cf breakin=off
This causes any Break In signals to be ignored
cf breakin=on
A rising edge on the Break In BNC will cause the probe to stop the processor
if it is running user code. There is a delay about 400 µsec of between
receiving the edge and stopping the processor.
Default: cf breakin=off
44
Advertisement
Table of Contents
