General Specifications - Tally Dascom 7010 Series Maintenance Manual

1-1. General Specifications

Printing
Printing method
Resolution
Max. print width
Max. print length
Print density
Printing speed setting
Print mode
Batch mode
Tear off mode
1
Cut mode *
2
Peel mode*
Media
Types of media
Recommended media Thermal transfer:
Max. media width
Min. media width
Min. label width
*1,*2: Options can be separately purchased.
Thermal transfer/Direct thermal
Main scanning line density:
203 dots/inch (8 dots/mm) (7010/7010R)
300 dots/inch (11.8 dots/mm) (7010-300)
Sub-scanning line density:
203 dots/inch (8 dots/mm) (7010/7010R)
300 dots/inch (11.8 dots/mm) (7010-300)
Head 864 dots (printable dots: 832 dots) (7010/7010R)
Head 1275 dots (printable dots: 1240 dots) (7010-300)
104 mm (7010/7010R)
105 mm (7010-300)
812.8 mm
Print density is adjustable with software
2 - 10 inches per second (7010/7010R)
2 - 8 inches per second (7010-300)
Normal printing (single or multiple sheets)
Feeds back media to the tear-off position after printing is completed.
Prints while cutting at designated sheet units.
The following two kinds of cut mode operations are done.
• Back feed
• Cut through
(Cut through refers to stopping part-way through printing the 'next
label' to make the cut. After cutting, printing restarts but there is a
chance of a small gap or mark at the temporary stop position.)
Peels labels from the liners after printing them.
Roll, fanfold
(continuous media, die-cuts, continuous tags, paper or tickets)
Direct thermal media:
118.0 mm
25.4 mm
7.62 mm
1-3
1-1. General Specifications
4.1 inch (7010/7010R)
4.1 inch (7010-300)
32 inch
4.65"
1.00"
0.30"