Tally Dascom 7010 Series Maintenance Manual page 68

2-3. Operation Panel
9. To check other submenu, repeat from Step 3. Otherwise, turn off the power to
terminate Factory/Service mode.
Operation procedure for "Service Counter" submenu:
1. Enter Factory/Service mode by turning on the power while pressing and holding the
[MENU], [FEED] and [STOP] keys.
"Factory Setup" main menu appears.
2. Press the [MENU] ( ) or [FEED] ( ) key until "Service Mode" main menu appears.
3. Press the [STOP] ( ) key to enter Service mode.
4. Press the [MENU] ( ) or [FEED] ( ) key until "Service Counter" submenu appears.
Service
Counter
Exit
5. Press the [STOP] ( ) key to select "Service Counter" submenu.
Then, the service counter length since the service counter is reset last is displayed.
* To reset the service counter, proceed to the next step. Otherwise, proceed to Step 7.
Length
0123.456 km
Exit
6. Resetting the service counter:
1) Press the [STOP] ( ) key.
2) Press the [MENU] ( ) or [FEED] ( ) key and select "Yes".
Exit
3) Press the [STOP] ( ) key to perform resetting.
7. Press the [PAUSE] ( ) key to return to "Service Mode" menu.
8. To check other submenu, repeat from Step 3. Otherwise, turn off the power to
terminate Factory/Service mode.
Enter
Enter
Reset?
No
Enter
Reset?
Yes
Exit Enter
2-52