Removing Rollers; Measure Sensor Rollers (4 Pcs.); Damper Roller (3 Pcs.) Of The Rewinder Cover Block; Damper Roller (4 Pcs.) Of The Rewinder Mechanism Block - Tally Dascom 7010 Series Maintenance Manual

3-5. Disassembly, Reassembly and Lubrication

(7) Removing Rollers

Note: The parts location Nos. (e.g. [2-61]) show the ones for 7010R. Refer to the Drawing No.
2 "Unit, Rewinder" for the Rewinder Part in Chapter 5 "Parts List".

(7-1) Measure Sensor Rollers (4 pcs.)

1. Remove the Rewinder Mechanism block referring to
Mechanism block".
2. Disengage 2 E-rings (E-Ring, 3) [2-61] on both sides and pull out the Damper Shaft [2-6] to
remove 4 Measure Sensor Rollers [2-7].

(7-2) Damper Roller (3 pcs.) of the Rewinder Cover block

1. Open the Rewinder Cover.
2. Disengage 2 E-rings (E-Ring, 3) [2-61] on both sides and pull out the Damper Shaft [2-6] to
remove 3 Damper Rollers [2-22].

(7-3) Damper Roller (4 pcs.) of the Rewinder Mechanism block

1. Remove the Rewinder Door referring to
Peeler".
2. Disengage 2 E-rings (E-Ring, 3) [2-61] on both sides and pull out the Guide Roller Shaft
[2-21] to remove 4 Damper Rollers [2-22].

(7-4) Peel Roll on the Printer part

1. Open the Rewinder Cover.
2. Remove 2 screws (PH (SW+PW), M3x5) [1-49] and detach the SA2, Peeler [1-45].
3. Disengage 1 E-ring (E-Ring, 4) [4-9], remove the Peel Roller Bushing2 [4-8], and pull out
the Peel Roll [4-1].

(8) Removing SA, Rewinder PCB

Note: The parts location Nos. (e.g. [2-59]) show the ones for 7010R. Refer to the Drawing No.
2 "Unit, Rewinder" for the Rewinder Part in Chapter 5 "Parts List".
1. Remove 4 connectors (J501, J502, J503 and J504) from the SA, Rewinder PCB [2-59].
2. Remove 4 screws (PH (PW+SW), M3x5) [2-64] and detach the SA, Rewinder PCB [2-59].
"(2) Removing the Rewinder
"(3) Removing the Rewinder Door and SA1,
3-40