Connection Of The Communication Accessories; Safety Instructions For Connecting The Communication Accessories - Ingeteam INGECON SUN PowerMax TL U B 1000 Vdc Series Installation And Operation Manual

Connection of the communication accessories

12. Connection of the communication accessories
This chapter explains the process for wiring the communication accessories to the unit.
There are several ways to achieve this communication with these units:
• Ethernet (standard).
• 3G.
INFO
To find the different components listed below, consult Section "2.6. Location of components".
Refer to Section "Important safety instructions" and the safety paragraph in this section before operating the
equipment.
See the corresponding communication accessories manual for further information.
Read carefully before starting the connection process.
12.1. Safety instructions for connecting the communication
accessories
DANGER
Before starting the connection process, press the emergency stop button and keep it interlocked until all the
connections required for the unit to operate correctly have been made.
Make sure there is no voltage present on the unit before carrying out any connections. Once the inverter is
switched off, wait at least 10 minutes until internal capacitances are fully discharged.
After connecting the communications accessories, do not switch the power on until you have made all other
connections and the unit has been closed.
Failing to apply the correct tightening torques to the connection terminals causes a risk of overheating and fire.
Use the Personal Protective Equipment specified in section "Personal Protective Equipment".
CAUTION
In order to keep the nuts and bolts of the unit in good condition it is important to make sure there is no dirt or
shavings in the threads when screwing them in and apply a suitable lubricant.
Ingeteam accepts no liability for any damages caused by an incorrect connection.
ABK2027IQE01_A - Installation and Operation Manual
Ingeteam
87