Active And Reactive Power Capacities - Ingeteam INGECON SUN PowerMax TL U B 1000 Vdc Series Installation And Operation Manual

Ingeteam
Test
Acronym
P
rated
[V , V ]
min max
V
nom
VW
MSA
Vac
MSA
watts
MSA
t
t
s
[V ,
start_min
V ]
start_max
[V ,
stop_min
V ]
stop_max
K
Power-Volt_Max
K
Power-Volt_Min
[t ,
VW return_min
t ]
return_max
[K ,
Power_Rate_Min
K ]
Power_Rate_Max
--
K
Power_Volt
K
Power_Rate
(*) Under frequency FW behavior has not been evaluated, nevertheless this operation mode could be obtained by the commands
from the power plant controller.

2.20.5. Active and reactive power capacities

The following chart shows the reactive power capacity of these units.
-150%
These units can support reactive power in the entire semicircle, depending on the output voltage.
40
Description
Output Power Rating
AC voltage range with function enabled
Nominal AC voltage
AC voltage accuracy
Output Power accuracy
Accuracy of time
Settling time
Adjustment range of the start of active power reduction
Adjustment range of the stop of the curtailment
function
Maximum slope of active power reduction
Minimum slope of active power reduction
Range of adjustment of a delay before return to normal
operation
Adjustment range of the rate of return to normal
operation
Use of hysteresis in the Volt-Watt function
Slope of the active power response to changes in
voltage
Active power rate of return to normal operation
-100% -50%
Reactive power (%)
100% Un
Parameters
100%
80%
60%
40%
20%
0 50%
90% Un
ABK2027IQE01_A - Installation and Operation Manual
Unit description
Units Defined value
Rated power
W
depending on model
Voltage range
V
depending on model
Nominal AC voltage
V
depending on model
%V 1%
%W 2%
s 0.0166
s
Voltage range
V
depending on model
V No hysteresis
Slope depending on
% /V
the rated voltage
Prated
Slope depending on
% /V
the rated voltage
Prated
s No hysteresis
%Prated/Sec No hysteresis
--
--
--
100% 150%
110% Un
2
No