Table of Contents
Advertisement
Installation Manual
Ingecon® Sun Three-Phase Inverter
3.4
GSM / GPRS - Modem communication connection
At the installer's request, optionally, the inverters may incorporate hardware to enable a
GMS / GPRS communication link to be established with the inverter.
Consult the communication accessory installation manual «AAX2002IKI01
Communication accessories Installation Manual.»
3.5
RS-485 line- Communication connection
At the installer's request, optionally, the inverters may incorporate hardware to enable
communication through an RS-485 serial line.
In all these units, the auxiliary signals are directly connected to card «AAP0022 Com
RS-485»
Consult the communication accessory installation manual «AAX2002IKI01
Communication accessories Installation Manual.»
3.6
Ethernet- Communication connection
At the installer's request, optionally, the inverters may incorporate hardware to enable
communication through Ethernet.
Consult the communication accessory installation manual «AAX2002IKI01
Communication accessories Installation Manual.»
3.7
Optical Fibre - Communication connection
Upon the installer's request and as an option, a hardware component for
communication via optical fibre can be installed on the Inverter.
On all these devices, the auxiliary signals are connected directly to the 'AAP0009
fibre optics' board.
3.8
Ground connections
The metal parts of the inverter (equipment ground) are electrically connected to the
ground plate located on the lower right side of the equipment.
To guarantee personal safety, this point must be connected to the installation
ground bar.
Ref.: AAS2000IKI02
Rev.:_
Dec-2009
Grounding
Pg. 15 de 40
Advertisement
Table of Contents
