Ingeteam INGECON SUN PowerMax TL U B 1000 Vdc Series Installation And Operation Manual page 168

Ingeteam
6. Uninstall the four M10 screws and remove the plate shadowed in the following figure. The tightening
torque for these screws is 30 Nm.
7. The phases are joined to each other via two connection busbars. Uninstall the M8 bolts from the phase´s
plates to replace. To uninstall phases -R and -T, you must remove 16 bolts. To uninstall phases -S you
must remove 32 bolts. The tightening torque for these screws is 8 Nm.
168 ABK2027IQE01_A - Installation and Operation Manual
Maintenance