Maintenance; Safety Conditions; Maintenance Tasks - Ingeteam INGECON SUN PowerMax TL U B 1000 Vdc Series Installation And Operation Manual

Maintenance

22. Maintenance
Throughout this chapter we will list the maintenance tasks along with preventative and corrective replacements for
proper inverter maintenance.
INFO
To find the different components listed below, consult Section "2.6. Location of components".
Refer to Section "Important safety instructions" and the safety paragraph in this section before operating the
equipment.
The various maintenance tasks must be performed by qualified personnel.

22.1. Safety conditions

DANGER
In order to perform the maintenance tasks considered voltage-free, or for preventative and corrective
maintenance, stop the unit with the emergency stop button and make sure there is not voltage prior to
performing any operation. Once the inverter is switched off, wait at least 10 minutes until internal capacitances
are fully discharged.
INFO
To disconnect the unit, follow the instructions in Section "20. Shutting down the unit".
To connect the unit, follow the instructions in Section "18.4. Power-up".

22.2. Maintenance tasks

Maintenance tasks are divided into three types: inspection, check and action.
Besides these three types, we group them relative to their frequency.
Inspection
This consists in observing the different elements without needing to operate them.
Check
This consists in observing the element´s status or performance via an operation.
Action
This consists in executing an action.
ABK2027IQE01_A - Installation and Operation Manual
Ingeteam
147