Connection Of Accessories; Safety Instructions For Connecting Accessories; Optional Accessories - Ingeteam INGECON SUN 1Play TL M Series Installation And Operation Manual

Ingeteam

8. Connection of accessories

Throughout this chapter, the process is explained for connecting the optional accessories in the unit, along with
the potential-free relay and the digital input.
Optionally, a communication system can be installed in order to establish a connection with the unit to monitor
and configure it, either locally or remotely, depending on the type of communication chosen and the needs of the
installation.
As standard these units have local communication via USB. In addition there is the option of establishing
connections using other technology types:
• RS-485.
• Ethernet (including communication via RS-485, for optional use).
• Ethernet TCP (including communication via RS-485, for optional use).
• GSM/GPRS (including communication via RS-485, for optional use).
• Bluetooth.
• Bluetooth (including communication via RS-485, for optional use).
See the corresponding communication accessories manual for further information.
Read carefully before starting the connection process.

8.1. Safety instructions for connecting accessories

Make sure there is no voltage present on the unit before starting the connection.
Do not switch on the power to the unit until you have successfully made the rest of the connections
and the unit is closed.
Ingeteam accepts no liability for any damages caused by incorrect connection.
Use the personal protective equipment specified in the section "Personal Protective Equipment
(PPE)".

8.2. Optional accessories

Depending on the type of accessory to install you must use the connector INGECON Connect or those marked as
INGECON Comm of the inverter power card.
If the accessory must be connected in the INGECON Connect, you must install the two vertical guides shown in the
figure above on the electronic circuit board, and use them to insert the card of the accessory.
After connecting the card or the corresponding connectors, insert the cable necessary for its proper installation into
the unit through the packing glands for the communication accessories.
68
Connection of accessories
ABE2011IQM01_B - Installation and Operation Manual