Connection For Ethernet Communication - Ingeteam Ingecon Sun Power Series Installation Manual

Ingeteam Power Technology, S.A.
Turn the comms board so that the connectors can be seen.
Connect the communications board exactly as shown in the following illustration.

5.4.9. Connection for ethernet communication

At the request of the installer, inverters may optionally incorporate hardware for communicating via ethernet. This
hardware is made up of an "AAX0004 Com Ethernet + RS-485" board.
The unit is provided with a 211 Ohm ferrite rod. The cable coming from the "AAX0004 Com Ethernet
+ RS-485" board (RS-485 output) must be inserted as close as possible to the board, turning it twice
around the hole at its centre.
The board is provided with a bag (attached with a plastic tie) containing the Ethernet cable. Connect the cable to the
board's Ethernet output and feed it out through the holes on the upper left side of the enclosure.
See "AAX2002IKH01 Installation Guide for Communications Devices".
Follow the same instructions given in the previous point for the connection of the board to the control board.
24
Installation manual
Connector for J11
Connector for J12
Communications board, rear view
J11
J12
AAS2000IKI01