Table of Contents
Advertisement
Ingeteam
14. Connection options
These units offer the possibility as standard of connecting various options for unit control and/or monitoring. The
installer can decide to use them or not depending on the requirements of each installation.
INFO
To find the different components listed below, consult Section "2.6. Location of components".
Refer to Section "Important safety instructions" and the safety paragraph in this section before operating the
equipment.
14.1. Safety instructions for connecting optional equipment
DANGER
Make sure there is no voltage present on the unit before carrying out any connections. Once the inverter is
switched off, wait at least 10 minutes until internal capacitances are fully discharged.
After connecting the wiring, do not switch the power on until you have made all other connections and the unit
has been closed.
Failing to apply the correct tightening torques to the connection terminals causes a risk of overheating and fire.
Use the Personal Protective Equipment specified in section "Personal Protective Equipment".
CAUTION
In order to keep the nuts and bolts of the unit in good condition it is important to make sure there is no dirt or
shavings in the threads when screwing them in and apply a suitable lubricant.
Ingeteam accepts no liability for any damages caused by an incorrect connection.
98
ABK2027IQE01_A - Installation and Operation Manual
Connection options
- Quick Links:
- Electrical Characteristics of the Unit
Hide quick links:
Advertisement
Table of Contents
