Display Control; Keypad And Leds - Ingeteam INGECON SUN PowerMax TL U B 1000 Vdc Series Installation And Operation Manual

Ingeteam

19. Display control

19.1. Keypad and LEDs

The keypad has four keys:
To exit a parameter, leave a menu and return to the next level up in the structure to not
confirm a change or not accept a suggestion.
With this key you can scroll up the list of parameters or folders within the same level or
increase the value of an editable parameter by one base unit.
With this key you can scroll down the list of parameters or folders within the same level or
decrease the value of an editable parameter by one base unit.
Its purpose is to accept a parameter as valid, to enter a lower level menu in the structure, to
confirm a change or accept a suggestion.
The front panel has three LEDs:
Green LED
Orange LED
Red LED
128
These inverters incorporate a display and keypad unit to interface with the installer
and the user.
This interface allows the display of the main internal parameters and the
configuration of the entire system during installation.
Parameters, variables and commands are organized as menus and submenus.
Off: inverter disconnected.
Slow flashing: Standby due to low irradiance.
Fast flashing: Start-up process.
On: Inverter connected to the grid.
This announces the existence of an alarm generated by an error external to the
inverter and the installation (for example, frequency error).
This announces the existence of an alarm generated by an error internal to the
inverter (for example, ventilation error).
ABK2027IQE01_A - Installation and Operation Manual
Display control