Setting The Step Size; Setting The Origin Point - GRAPHTEC CE3000-40 User Manual

I Setting the STEP SIZE
If the GP-GL command mode is set, it is possible to change the minimum unit of distance that the cutter
pen or pen can travel to one of four settings: 0.01 mm, 0.025 mm, 0.05 mm, or 0.1 mm. The default setting
is 0.1 mm, so this setting should be changed if your application specifies a different step size.
1
Step
Set the command setting to "GP-GL."
C O M M A N D G P - G L
2
Step
Press the (ENTER) key to display the step-size setting.
S T E P S I Z E 0 . 1 0 0 m m
3
Step
Press the or key to select "0.100 mm," "0.050 mm," "0.025 mm," or "0.010 mm," and then press
the (ENTER) key to confirm. To cancel the selection, press the
4
Step
Press the (PAUSE) key to cancel the PAUSE mode.
I Setting the ORIGIN POINT
If the HP-GL command mode is set, the origin point can be set to the lower left or center. The default set-
ting is the lower left, so this setting should be changed if your application specifies a different origin posi-
tion.
1
Step
Set the command setting to "HP-GL."
C O M M A N D H P - G L
2
Step
Press the (ENTER) key to display the origin-point setting.
O R I G I N P T L . L .
3
Step
Press the or key to select "L.L. (LOWER LEFT)" or "CENTER," and then press the
key to confirm. To cancel the selection, press the
4
Step
Press the (PAUSE) key to cancel the pause mode.
(NEXT) or
(NEXT) or (PREV.) key.
3 – 3
(PREV.) keys.
(ENTER)