Connector Pin Assignments; Preventive Maintenance; Retrieving Banknotes - JCM GLOBAL VEGA Series Operation And Maintenance Manual

Section 2

Connector Pin Assignments

Table 2-5 lists the VEGA Interface Connector Pin Assignments.
*
Signal Name
Pin No.
1
VDD1
2 VSS1
3 RS232C-RXD
4 PC-RXD
5 PC-TXD(MDB)
6 PC-COM
7 VEND3(BUSY)
8 SG
9 INHIBIT3(Soft-R)
10 INHIBIT4
11 INHIBIT1 (TTL-RXD)
12 INHIBIT2(D/E)
13 RTS/FULL
14 VEND4(RS232C-TXD)
15 VEND1(cc-Talk)
16 VEND2(ABN)
*. NOTE: The listed Pin Numbers are different from the Pin Numbers actually printed on the Circuit Board. Be sure that the Pin Numbers printed on the
Connector entry point.
†. I/O (Input/Output) is the Terminal viewed from Banknote Validator's Bezel opening.
‡. Be sure to use the correct Supply Voltage Specification Parts (Use the 24V DC Specification Item when using 24V - 36V DC Option).
**. ccTalk dual circuit used.

Preventive Maintenance

Retrieving Banknotes

To retrieve Cash Box deposited Banknotes, perform
the following steps:
1. Pull and remove the Cash Box from the Frame
(Figure 2-7 a).
2. Rotate the Thumb Lock Knob counterclockwise
and lower the Cash Box Door (Figure 2-7 b).
3. Retrieve the Banknotes from the Cash Box 
(Figure 2-7 c).
P/N 960-100189R_Rev. 4 {EDP #148850}
VEGA™ Series Banknote Validator
Table 2-5 VEGA Pin Assignments
VEGA Interface Connector
As Viewed From Front Side
Box Pin Header: PS-16PE-D4LT1-PN (JAE)
Socket Housing: PS-D4C16
Contact Type: 030-51304-001
Recommended Wire: UL1007 AWG #24~26 (Slit Type)
†
I/O
--
12V DC (Option: 24V - 36V DC)
-- GND
IN Serial data signal input line from Controller to Validator
IN Serial data signal input line from Controller to Validator
OUT Serial data signal output line from Validator to Controller
-- Photo-coupler Common (Ground)
OUT Serial data signal output line from Validator to Controller
-- Signal Ground
IN Serial data signal input line from Controller to Validator
IN Serial data signal input line from Controller to Validator
IN Serial data signal input line from Controller to Validator
IN Serial data signal input line from Controller to Validator
OUT Serial data signal output line from Validator to Controller
OUT Serial data signal output line from Validator to Controller
(RS232C output line alternative)
**
Serial data signal I/O line from Validator to Controller
IN/OUT
OUT Serial data signal output line from Validator to Controller
Figure 2-7 Retrieving Banknotes
2 - 4
Function
‡
a
b
Figure 2-7 Retrieving Banknotes
© 2016, JAPAN CASH MACHINE CO., LTD.
Installation
c
Knob