Mode Selector Switch - Phoenix Contact ILC 330 User Manual

UM EN ILC 330/350
2-8
PHOENIX CONTACT
2.7

Mode Selector Switch

The mode selector switch is used to define the operating state of the application program.
The RUN/PROG and STP positions have a toggle button function and the MRESET
position a pushbutton function. After releasing the button in the MRESET position, it is set
back to the STP position.
Table 2-1 Inline Controller operating modes
Operating Explanation
Mode
RUN/PROG The application program is in the RUN state.
The PC WorX software can be used for program and configuration
changes.
The monitoring and online functions can be used.
STP The application program is in the STOP state.
MRESET Retain data and the application program are deleted.
For reasons of safety, use the mode selector switch in the following
order for deleting the data:
• Hold in MRESET position for three seconds.
• Release for three seconds.
• Hold in MRESET position for three seconds.
Figure 2-6 Mode selector switch
6959_en_05