Maintenance - Clamp Pressure Adjustment Screen - Horizon Fitness APC-61 II Manual

1-2 Control Panel Screen Descriptions

1-2-12 Maintenance - Clamp Pressure Adjustment Screen

This screen is used to adjust the paper clamp pressure.
If this screen is displayed on the control panel, the machine changes
automatically into the pressure adjustment mode.
Maintenance Mode Screen
Operation by the cutting buttons in the Pressure Adjustment Mode
1. When both cutting buttons are pressed, only the clamp lowers.
Keep pressing both cutting buttons and read the pressure indicator.
- If either button is released, the pressure indicator returns to "0."
- If the pressure gauge returns to "0", press both cutting buttons again to raise the
clamp. Then, press both cutting buttons again to lower the clamp and check the pressure.
To release the Pressure Adjustment Mode, display the Cutting Mode Screen on the control
panel and press both cutting buttons. Now the knife and clamp will move at the same time.
Clamp Pressure Adjustment Screen
Back Button
Goes back to the Maintenance
Mode Screen
(13)