1-2
Control Panel Screen Descriptions
1-2-11 Maintenance - Push-out Length Setting Screen
This screen is used to change the push-out length.
The "push-out" function sets the distance the sheets are pushed forward after they
are cut, so that they can be removed easily.
This is set to 50 mm (1.970") at the factory. The setting is adjustable within the range
of 20 mm (0.785") to 150 mm (5.905").
"Maintenance" Mode Screen
(12)
2
"Push-out Length Setting" Screen
Push-out Length Input
1
This is adjustable from 20 mm (0.785") to 150 mm (5.905").
Back Button
2
The display goes back to the "Maintenance" Mode Screen.
1