Operating Procedures; Cutting Operation On The Cutting Line - Horizon Fitness APC-61 II Manual

4. Operating Procedures

4-1

Cutting Operation on the Cutting Line

Use this procedure to cut the sheets at the
cutting line (the line where the knife hits the
paper.)
Press the button, then the
tab.
To push out the sheets after they have been
cut, press the button.
Align the sheets using the
backgauge and the side guide.
- If you need more light, turn ON the light
switch on the side of the electrical box.
- Start by setting the backgauge a bit
behind the final cutting position. This
makes it easier to adjust the backgauge
into the correct final position.
Press the backgauge forward or
backward buttons to position the
backgauge so the cut will be
made just behind the desired
cutting line.
Normal Cutting Screen
Side Guide
Backgauge
Rear View
Light Switch
Backward Button
High Speed Motion Button
Forward Button
Push-out
Button
O N
F
O F
(31)