5-3
The Sheets Are Not Cut Parallel
Cutting Face
The sheets have not been aligned correctly by the
backgauge.
The backgauge is not parallel to the knife.
5-4
The Top Sheet Is Marked By the Clamp
Clamp Mark
The clamp pressure is too strong.
5-5
The Sheets Are Contaminated With Grease
If too much grease has been applied, the extra
grease may get onto the paper.
The amount of grease used changes depend-
ing on the frequency of use of the machine. If
the machine is used every day, apply the
grease once a week. If you notice extra grease
leaking onto the paper, apply grease less often.
(60)
Top View
C a u s e
C a u s e
C a u s e
R e m e d y
Check that the sheets are aligned by the
backgauge correctly.
Adjust the backgauge so it is parallel to the knife.
(See Section 6-7: "Backgauge Parallel
Adjustment")
R e m e d y
Install the clamp support plate on the clamp.
(See Section 4-6: "Clamp Support Plate")
Reduce the clamp pressure.
(See Section 6-4: "Clamp Pressure Adjustment")
WARNING
Turn OFF the power switch before
cleaning the machine. The machine
can cause severe personal injury.
R e m e d y
Wipe off any extra grease on the cutting unit.
Extra grease
leaks out here.