Horizon Fitness APC-61 II Manual page 91

7-3 Connecting the Power Cable
Turn ON the power switch.
CAUTION
- Perform the steps
continuously. Otherwise, the
hydraulic pump may be dam-
aged.
- In step
buttons to perform the cut. If
the knife does not lower, turn
off the power switch immedi-
ately. Otherwise, the hydraulic
pump may be damaged.
Turn ON the key switch.
Press both cutting buttons at
once.
- If the knife does not lower, turn OFF the power
switch immediately. Change the positions of two
of the power wires, as described in step 7 and 8
below.
- If the knife does lower, the power connections
are OK.
- If the machine is used in an area where the AC
line frequency is 50Hz, go to the next page to set
the machine to use this frequency.
Turn off the circuit breaker for the
power board.
Exchange the positions of any
two of the three black cables. (Do
not move the yellow/ green
cable.)
Repeat steps
until the knife lowers when the
cutting buttons are pressed.
(84)
and
, press cutting
through
- Knife lowers
OK
- Knife does not lower
NG
Turn OFF the power
switch immediately.
Knife
Power
Cable
1 2 3
Black Black Black Yellow/Green
Key Switch
F
O F
O N
O N
Power Switch
Ground