An Error Code Appears - Horizon Fitness APC-61 II Manual

5-9

An Error Code Appears

Error
Code Error Type
0101 Knife Lower Limit Error
0801 Memory Error
0802 Memory Full
1051 One Beam Sensor Error
1061 Safety Beam Error
1151 Knife Upper Limit Error
1351
Backgauge Servo Motor
Error
1361
Backgauge Servo Motor
1362
Home Position Error
1363
1851 Memory Error
(62)
0101
Remedy
The lower limit of the knife position is too low. Raise the knife a little
1.
using the cutting depth adjusting dial.
The knife does not move up or down smoothly. Apply grease to the
2.
grease nipples on the front and rear of the machine.
If this error occurs frequently, please notify us.
The program memory is full. Delete any unnecessary programs.
Stop operation immediately, and please notify us.
Stop operation immediately, and please notify us.
The knife does not move up or down smoothly. Apply grease to the grease
nipples on the front and rear of the machine.
1.
Check that there is nothing preventing the backgauge from moving.
2.
Add oil to the backgauge lubrication unit.
Turn OFF the power switch. After 10 seconds or more, turn it ON
again.
Note:
3.
If the power switch is turned ON immediately after it is turned OFF,
this error may occur. Be sure to wait 10 seconds or more before
turning ON the power switch again.
Turn OFF the power switch. After 10 seconds or more, turn it ON again.
Turn OFF the power switch. After 10 seconds or more, turn it ON
1.
again.
2.
Clear all stored programs.
Re-enter the value for the backgauge home position that was
originally set at the factory.
3.
The value that is set at the factory is listed on the label on the rear
cover of the control panel.
Input a value from 20 to 150 mm (0.790" to 5.905") into the Push-out
4.
Length area again.
Error Screen
Note the number of the error code, then check
the table below to correct the problem.
Correct the problem, then to clear the error,
press the button.
OK
R e f e r e n c e
P a g e
73
78
-
46
-
-
78
-
-
-
-
46
75
57