Entering A Value - Horizon Fitness APC-61 II Manual

3-2

Entering a Value

When you press a numeric input area on the
screen such as Cutting Length Input, the Numeric
Keypad Screen appears.
On the Numeric Keypad Screen, the number can
be entered directly. The results of a calculation
can also be entered using the
buttons.
(When doing division, the result is rounded to one
decimal place.)
For example, the calculation for one-third of 558.9 is:
.
5 5 8 9
Press the buttons as shown above. The result of
186.3 is indicated on the Numeric Keypad Screen.
A number can be divided or multiplied (
only by whole numbers.
If the result of 186.3 is OK, press the
button. The value will be entered.
During a cutting operation, if you want to make the
sheets longer or shorter than the current cutting
length, you do not have to re-enter the corrected
value directly. The value can be changed by using
the and buttons.
For example, if you cut the sheets at 400.0 mm,
and you want to make the length shorter by 10.0
mm, for a total of 390 mm:
1. Press the Cutting Length Input on the Normal
Cutting Screen.
2. On the Numeric Keypad Screen, press
.
1 0 0
The value 390.0 will be indicated.
=
Press ent again to enter the value.
Multiplication and division are also available by
using the and buttons.
3
= ent
)
=
ent
=
ent
Normal Cutting Screen
186. 3
Numeric Keypad Screen
Normal Cutting Screen
400.0
400. 0
Numeric Keypad Screen
- 10.0
390. 0
Cutting Length
Input
= ent
(27)