This chapter describes the basic operation of the machine. Please read
the instructions on this chapter, then go to Chapter 4: "Operating Procedures."
3-1
Selecting the Control Panel Screen
Selecting a Mode
- There are basic four operating modes for the
control panel.
- Press the buttons on the left side of the screen to
select the operating mode.
: "Cutting" Mode
Use this mode during the cutting operation.
: "Memory" Mode
Use this mode to set up the various cutting
programs (cutting length and other set-
tings) and store them.
: "Compression" Mode
Use this mode to do a compression
operation (reduce the bulk of a booklet
using the clamp pressure.)
: "Maintenance" Mode
Use this mode to do maintenance
(lubrication, knife replacement and clamp
pressure adjustment, etc.), and to check
the state of the machine.
Selecting the Cutting Mode Screens
The Cutting Mode includes two screens; Normal
Cutting Screen and Program Cutting Screen.
To select one of these, press the tabs at the top of
the screen.
3. Basic Operation
Cutting Mode
Normal Cutting Screen
Program Cutting Screen
(25)