Backgauge Check - Horizon Fitness APC-61 II Manual

2-5

Backgauge Check

Check the motion of the backgauge.
Check that the power switch and
the key switch are both turned
ON.
Press the Cutting Length Input on
the Normal Cutting Screen.
The Numeric Keypad Screen appears.
Enter 25 (mm) (or 0.985"), and
press the
=
ent
If the clamp support plate is installed, the
value 25 (mm) (0.985") can not be entered.
Remove the plate and replace it on the
bracket on the rear of the machine.
Check that the backgauge moves, and the
current length is shown as 25.0 (mm) (or 0.985").
button.
Clamp support plate
Normal Cutting Screen
Cutting Length Input
25. 0
Numeric Keypad Screen
Normal Cutting Screen
25. 0
Clamp
Support Plate
(23)