Horizon Fitness APC-61 II Manual page 39

4-1
Press the backgauge forward
button to align the desired cutting
position with the cutting line.
Each time the forward button is pressed, the
backgauge moves forward by 0.1 mm (0.004").
As the backgauge pushes against the sheets,
the sheets are aligned accurately.
Step on the foot pedal to lower
the clamp. Check the cutting line.
- The width of the light is about 1.5 mm (0.06"),
so it gives a rough indication of the cutting line.
However, when the clamp is lowered, the cutting
position can be checked more accurately.
- The knife lowers in front of the clamp by 0.6
mm (0.024").
Press both cutting buttons.
- The machine cuts the sheets.
- To prevent the sheets from moving during the
cutting operation, continue to step on the foot
pedal to hold the clamp down.
Check that the clamp and knife
stop at the correct positions, then
release the cutting buttons.
After completing all cutting opera-
tions, turn OFF the key switch and
power switch.
Pull out the key and keep it in a safe place.
(32)
Cutting Operation on the Cutting Line
High Speed Motion Button
Forward Button
Knife
0.6 mm
(0.024")
O F F
Power Switch
Backward Button
Clamp
Cutting Buttons
Foot Pedal
F
O F
O N
Key Switch