Horizon Fitness APC-61 II Manual page 44

4-3 Creating a Cutting Program
Set the repeat function.
Use the repeat function to make the same cut
more than once.
- To use the repeat function, press the
button, and indicate how often the cut should be
repeated.
- If you enter "0" for the frequency, the machine
repeats the same cut as many times as possible,
until the distance to the backgauge is less than
the minimum cutting length. See the drawing to
the right.
Repeat steps through
set up all of the steps.
Programming Screen
05
06
With this program, the machine runs as shown
below.
Knife
100
100 100
100 100 100
100 100 100 100
If the backgauge tried to move another 100 mm, the
remaining 20 mm would be less than the minimum
cutting length.
Therefore, unless the step 7 is set up, the machine will
think it has reached the end of the program, and go
back to step 1.
and
Input the frequency
to repeat on the
Numeric Keypad
Screen.
520. 0
100. 0
00
5 Step 520
Backgauge
6-1
420
6-2
320
6-3 220
6-4 120
(37)