Knife Height Adjustment; Cutting Depth Adjustment - Horizon Fitness Horizon PC-45 Instruction Manual

6. Maintenance

6-3 Knife Height Adjustment

6-3-1 Cutting Depth Adjustment

Cutting depth must be adjusted after knife
replacement.
WARNING
- Operating PC-45 before cutting depth
is adjusted may cause some troubles.
1.
Turn clamper hand wheel to lower pres-
sure.
2.
Unplug power cord.
3.
Open knife adjust cover.
NOTE
- Turn lock nut clockwise to loose lock nut.
4.
Loosen two lock nuts of knife height
adjust screws with spanner.
5.
Turn turnbuckle with adjust bar into adjust
screws hole to fit knife with the mark with
felt pen.
NOTE
- 1/6 turn of knife height adjust bolts raise/
lower knife about 0.6 mm. Excessive cutting
pressure does harm to PC-45. Maximum
cutting depth is 0.5 mm.
6.
Fasten two locknuts.
7.
Close knife adjust cover on the bottom.
Knife Adjust Cover
Fasten
Spanner
Turnbuckle
Raise
Adjust Bar
34
Loosen
Lock Nuts
Lower
Adjust Screw Hole