Horizon Fitness APC-61 II Manual page 43

4-3 Creating a Cutting Program
Input the cutting length.
1) Press the Cutting Length Input area.
The Numeric Keypad Screen appears.
2) Input the value on the Numeric Keypad Screen,
and press the =
The new input value is entered, and it is shown
on the Cutting Length Input area for that step.
- When using the
descirbed in step
the cutting width. When the
is selected in the first step, the cutting line
moves backward from the current posi-
tion by the entered distance.
- Once the cutting length has been input,
the step moves to the next number
automatically.
- The cutting length can be set within a
range of 25 mm to 620 mm (0.985" to
24.410").
[If the clamp support plate is installed, the
range is 65 mm to 620 mm (2.560" to
24.410"). ]
When a value of less than 25 mm (0.985")
[or 65 mm (2.560")] is entered, the ma-
chine judges that as the value for the
cutting width of the repeat function (step
), and the repeat function is turned ON
automatically.
- The value indicated on the Normal Cutting
Screen can also be used as the cutting
length in this step. Press the
If an earlier value was already saved, the
new value will be overwritten.
Set the push-out function.
The "push-out" causes the sheets to be
pushed out after cutting so they can be
removed easily.
-
To use the push-out function, press the
button.
-
The distance of the push-out can be changed
within a range of 20 mm to 150 mm (0.785" to
5.905"). Refer to Section 4-7: "Changing the
Push-out Length."
(36)
button.
ent
(repeat function,
), enter a value for
function
button.
Programming Screen
300. 0
Numeric Keypad Screen
Programming Screen
300. 0
1
000. 0
2
3 000. 0
Programming Screen
Cutting Length
Input