Cutting - Program Cutting Screen - Horizon Fitness APC-61 II Manual

1-2 Control Panel Screen Descriptions

1-2-4 Cutting - Program Cutting Screen

This screen is used to cut the sheets using a stored program.
The backgauge is set automatically by the program, so a cutting
operation can be repeated.
1
8
4
Program Number Input
When this is pressed, the Program Select Screen appears. (See Page 8.)
1
On that screen, press the program number you want to recall, and press the
will be recalled.
Current Length Indicator
2
The current position of the backgauge is indicated here.
Program Start Button
After a program is recalled, when this button is pressed, the machine starts the program cutting
3
operation from the step displayed in the middle of the list.
Step Heading Button
4
When this button is pressed, the first step in the program is displayed in the middle of the list.
Step Backward Button
5
Each time this button is pressed, the previous step is displayed.
Step Forward Button
6
Each time this button is pressed, the next step is displayed.
Calibration Value /Push-out - Repeat Select Button
7
Each time this button is pressed, the function changes:
Step Indicator
8
These indicate the type of information displayed below: step number, cut length, and push-out distance.
Calibration Value Input
9
When the value saved by the program needs to be calibrated, enter the calibration value here.
(The adjustable range is
2
9
5 6 7
9.9 mm (0.390"). A value beyond the max. or min. cutting length can not be entered.)
3
button. The program
(calibration) and (push-out/repeat.)
(5)