Cutting And Clamp Section - Horizon Fitness PC-P430 Manual

3 Descriptions of Mechanisms

3 - 1 Cutting and Clamp Section

3 - 1 - 1 Cutting and Clamp Mechanism
DU Bushing
(Compressed into the drive cam)
This oilless bearing
supports the drive
cam.
Crank
Cam Mechanism Front View
Adjusting Screw
CAUTION:
The adjustable range is
±45 degrees. If you turn
the screw more, the
screw may be broken.
S03
Cam Switch A
Position of Cam and Switches
When the knife runs in normal
direction and it is at the upper
S03
limit, the cam must not press
the actuators of S03 and S04.
Clamp
(Fig.6-1)
Ring
(Fig.6-7)
Cutting
Stick
Drive Cam
6
5
4
Knife Holder
Drive Cam
3
(Fig.6-37)
2
1
S04
Cam Switch B
Actuator
S04
Holding Plate
Normal
(Fig.6-19)
Direction
Cutting and Clamp Section
M01
Main Motor
(Fig.6-41)
404018
3_1_1A
Keeper Screw (2 and 5)
• The four screws 1, 3, 4 and 6 that
are shown in the left above lock the
holding plate for the knife.
• Screws 2 and 5 prevent the knife
from dropping when the screws 1, 3,
4 and 6 are loosened by the vibra-
tion of the machine. A special tool is
required to loosen screws 2 and 5.
PC-P430
This spring
presses down the
clamp.
The clamp is
hooked on the
knife holder.
The edge of the clamp is always
below the edge of knife.
The cut line is the light from this space.
Eccentric Pin
(Fig.6-16)
Marker Hole
A
A
Part B is eccentric to part A. Insert the screw driver
to the straight slot and turn the pin to adjust the
knife angle.
32
B