Installing The Control Panel - Horizon Fitness APC-61 II Manual

7-2
WARNING
Do not connect the power
cable before installing the
control panel. Install the
control panel only when the
power is OFF.
Remove the two eyebolts.
Install the control panel unit on
the top of the machine.
Use the four mounting screws.
Remove the right rear cover of
the machine.
Connect the cable from the con-
trol panel to the machine.
- Plug in the two connectors.
- Attach the cable using cable ties (accessory) at
the following positions:
1. On the cable from the area sensor, near the
top frame of the machine.
2. On the cover support, along with the cable
from the area sensor (already tied onto the
cover support.)
Replace the right rear cover.
Do not let the cover pinch the cable.
Install the cable cover.
- Install the cover on top of the machine so it
protects the cable.
- Tighten the cable to the cover using a cable tie.
Insert the two caps (accessory)
into the holes for the eyebolts.
(82)

Installing the Control Panel

Control Panel Unit
Right Rear Cover
Screw
Cable Tie
Tighten on the
cable from area
sensor
Tighten on the
cover support
Eyebolts
Screw
Cable Cover
Connectors