Preparing the IntelliStart Fluidics system
For additional information, see
line" on page
Caution:
store large volume solvent reservoirs on top of the instrument.
Installing the reservoir bottles
Use standard reservoir bottles (30 mL) for instrument setup and calibration.
Use the Low-volume Adaptor Kit (included) to infuse smaller volumes. The
low-volume vials have a volume of 1.5 mL.
Required materials
Chemical-resistant, powder-free gloves
To install the reservoir bottles:
Warning:
biohazardous and/or toxic materials. Always wear
chemical-resistant, powder-free gloves while performing this
procedure.
1.
Remove the reservoir bottle caps.
2.
Screw the reservoir bottles onto the mass spectrometer, as shown below.
2-6
Preparing the Mass Spectrometer for Operation
Appendix D
B-22.
To avoid accidental spillage damaging the instrument, do not
The reservoir bottles can be contaminated with
and
"Connecting the liquid waste
Reservoir bottle
Solvent delivery tube