Wiring
6.2
Block diagram
The following block diagram provides an overview of the wiring of the servo amplifier. The
wiring of the expansion cards is not shown.
The block diagram also shows the position and type of shield connections, the PE and the
connections of the attached device to the mounting plate.
*) Please note: If you are using an external brake resistor, remove the link between Pin 4
and 5 on X8.
Symbol Connection
Operating Manual PMCtendo DD5
1002236-EN-04
Description
X1, X2, X6, X9 Shield in the connector housing
X3, X8
Shield on the front plate
PE
Protective earth, PE
Mounting plate Wide area, electrical connection between the designated
device and the mounting plate in the control cabinet
79