Ricoh FT3020 Field Service Manual page 48

5. Secure one end of the new wire with the
anchor screw.
6. Run the wire under the inside track of WP1
and then through the wire clamp to WP2.
7.
Next, set the wire in the inside track of WP2
and then run it over the inside track of WP3.
8.
Wrap the wire around the scanner drive pulley
(WP4) 4 times counterclockwise, starting
from the inside edge of the pulley.
9. Then, run the wire over the outside track of
WP5 and under the outside track of WP6.
10. Next, run the wire over the outside track of
WP1 and around WP7.
11. Hook the free end of the wire to the tension
spring.
12. Tighten the wire clamp.
13. Manually rotate the main pulley and check for
overlapping of the scanner drive wire.
14. Reassemble the copier.
6-8
15. Check and adjust the magnification (See 6G-
1 ) .