Ricoh FT3020 Field Service Manual page 124

4. Turn off the main switch and then turn off DIP
SW #2 on the switching board.
5. Turn on DIP SW #1 on the switching board.
6. Turn on the main switch and adjust the
separation corona DC current by turning
"VR.DC" on the T/S power pack.
7.
Turn off the main switch and then select the
AC µA range of the digital multimeter.
8. Turn on the main switch and adjust the
separation AC current with "VR.D" on the T/S
power pack.
9. Turn off the main switch and select the DC µA
range of the digital multimeter.
10. Turn on the main switch and check the
separation DC current again.
6-76