Table of Contents
Advertisement
Communications Submenu
Figure 29.
Communications Submenu
The Communications submenu enables you to view the serial port baud rate and the unit media access control
(MAC) address, and to configure the IP address, subnet mask, and gateway address, and DHCP mode.
•
Serial Port Baud Rate — Displays the baud rate for the Remote RS-232 serial port (view only). The default
is 9600.
•
MAC Address — Displays the MAC address of the device (view only).
•
DHCP Mode — When this mode is enabled (On), the unit obtains an IP address and other network settings
from the DHCP server. The default is Off.
To enable or disable DHCP mode:
1. Highlight DHCP Mode on the Communications submenu and press Enter.
2. Press the
>
You can also set the DHCP mode via an SIS command (see
software, or the internal web page (see
•
IP Address — Press the
adjust the value of the selected octet. The default is 192.168.254.254.
•
Subnet Mask — Press the
buttons to adjust the value of the selected octet. The default is 255.255.255.0.
<
•
Gateway — Press the
to adjust the value of the selected octet. The default is 0.0.0.0.
or
button to select On or Off, and press Enter again.
<
Network Settings Panel
and
buttons to select an octet of the IP address. Press the
u
and
buttons to select an octet of the subnet mask address. Press the
u
and
buttons to select an octet of the gateway address. Press the
u
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • Operation
Set DHCP mode
on page 69), the PCS
on page 97).
>
and
buttons to
<
>
and
>
and
buttons
<
40
Advertisement
Table of Contents
