Pitney Bowes Connect+ Series Operator's Manual page 340

Maintenance
2. Select the location on the envelope where most full color graphics are printed.
Do not change this setting unless instructed to do so.
Select Left if most full color graphics are printed as part of the return address.
l
Select Center (recommended) if most full color graphics are printed as part of a graphic or
l
text message.
Select Right if most full color graphics are printed as part of a permit.
l
Select Next to continue.
3. Place an envelope on the feed deck and select Start to print the vertical test pattern.
4. Select the Pattern number: field.
1. Type in the number of the best aligned pattern.
2. Select OK.
3. Select Next to continue.
5. Repeat steps 3 and 4 to print the second vertical test pattern.
6. If the alignment was successful, a message appears indicating that the print heads have been
vertically aligned to print on envelopes. Select Next to continue to the horizontal alignment.
7. Place an envelope on the feed deck and select Start to print the first horizontal test pattern.
8. Select the Pattern number: field.
a. Type in the number of the best aligned pattern.
b. Select OK.
c. Select Next to continue.
9. Repeat steps 7 and 8 to print the second horizontal test pattern.
10. If the alignment was successful, a message appears indicating that the print heads have been
aligned to print on envelopes. Select Done.
Tape alignment only
1. Select Tape to print the first vertical test pattern.
Pitney Bowes Connect+ Series Operator Guide April, 2016 Page 340 of 367