Hardware Settings - Pitney Bowes Connect+ Series Operator's Manual

System Setup

Hardware settings

The Hardware settings allow you to view general information about your system, perform routine
maintenance procedures and to adjust hardware settings.
General: Select this option to
l
Printer: Select this option to
l
pattern.
Tape: Select this option to rewind tape for removal and to bring tape to the ready position once a
l
new roll has been inserted.
Sealer: Select this option to view the location of the envelope sealant bottle and the moistener pad
l
and to adjust the moistness of the
Attached scale: Select this option to
l
Feeder: Select this option to
l
WEIGH-ON-THE-WAY® (W-O-W®): Select this option to
l
weight limit.
Viewing your model and serial number
The model and serial number are helpful to have on hand for rate changes, phone support, and service.
1. Select the Settings button in the Mailing tile on the Home screen.
2. Select Hardware from the list on the left side of the screen.
3. Select General. Your system name, model number, PSD PCN, PSD serial number, printer PCN
and printer serial number display on the screen.
4. Select the Home button to return to the Home screen.
Changing the scale vibration setting
You can turn the vibration filter on if your mailing system is in an environment subject to vibrations, such
as near air-conditioning vents or closing doors. If you select this, the scale will require more time to settle
before displaying a weight.
Pitney Bowes Connect+ Series Operator Guide
view the model and serial
replace the ink cartridges,
sealer.
zero the scale
adjust the waiting for envelope
April, 2016
number.
replace the print head, or
or to change the vibration
timeout.
select the weighing mode
print a test
setting.
or to set the
Page 310 of 367