Refilling Your Meter - Pitney Bowes Connect+ Series Operator's Manual

Refilling your Meter

Refilling your meter

Use the Funds application to refill your meter.
1. You can access the Funds application by selecting the Funds button in the Mailing tile on the
Home screen, selecting the Postage in meter button on the bottom of the Run Mail screen, or
selecting Add Postage to Meter when you receive a low funds warning or an insufficient funds
error.
2. If necessary, select the Meter Funds tab.
3. If necessary, select the Refill my Meter button.
4. Select the appropriate refill amount option:
To add the same postage amount that was used during the last refill select the Last refill
l
amount button.
To add the default postage amount select the Default refill amount button.
l
To add a different postage amount select the Other amount button. Type in the refill amount
l
and then select the OK button.
Note:
The maximum and minimum postage refill amounts for your system are listed on the Meter
information tab.
5. When prompted, select Confirm. The system connects to the Data Center and begins to refill your
meter.
6. The system will notify you when it finishes adding your postage. If you want to print a receipt select
the Print receipt button.
To print the receipt on an envelope, place an envelope of the feed deck and select the Start
l
button.
To print the receipt on a piece of tape, select the Tape button.
l
If you have an optional attached printer, select the Print on document button.
l
7. Select Done to exit the Funds application.
Pitney Bowes Connect+ Series Operator Guide April, 2016 Page 272 of 367