Replacing A Power Module (For 5600 V5/5800 V5/5600F V5/5800F V5) - Huawei OceanStor V5 Series Parts Replacement

OceanStor V5 Series
Parts Replacement
Figure 6-31 Running/Alarm indicator on a power module
Step 12 Confirm the replacement.
After the preceding procedure is complete, check services on the host for storage-
related errors. If any storage-related error is reported, contact Huawei technical
support.
----End
Follow-up Procedure
After the power module is replaced, label it to facilitate subsequent operations.
6.2.3 Replacing a Power Module (for 5600 V5/5800 V5/5600F
V5/5800F V5)
This section describes how to replace a power module. Except that there is a slight
difference on removing and inserting power cables between AC and DC power
modules, other operations performed for them are the same. This section uses AC
power modules as an example.
Impact on the System
During the replacement of a power module, if the redundant power module fails,
the corresponding controller is powered by a BBU and the system reliability
degrades.
Prerequisites
●
●
Issue 15 (2019-12-30)
The spare part is on hand.
The power module that you want to replace has been located.
You can locate a component in either of the following ways:
● Locating a component based on alarms in DeviceManager: On the Alarms and Events
page of DeviceManager, view the help information and determine the ID of the
component to be replaced. Then locate the component at your site based on its ID.
● Locating a component based on the status of its Running/Alarm indicator: For details
about the indicators on different components, see Indicator Introduction of each
Product Description specific to your product model and version.
component in the
Copyright © Huawei Technologies Co., Ltd.
6 Replacing CRUs
44