Replacing An 8 Gbit/S Fibre Channel Interface Module (Eight Ports)/16 Gbit/S Fibre Channel Interface Module (Eight Ports) - Huawei OceanStor V5 Series Parts Replacement

OceanStor V5 Series
Parts Replacement
The cable connection positions of the new interface module must be identical to
those of the original interface module. Otherwise, service operation will be
affected.
Step 10 Wait approximately two minutes and check the status of the Power indicator on
the interface module to determine whether the interface module has been
successfully installed.
●
●
Figure 7-82 Power indicator on an interface module
Step 11 Confirm the replacement.
1.
2.
3.
----End
Follow-up Procedure
After the interface module is replaced, label it to facilitate subsequent operations.
7.8 Replacing an 8 Gbit/s Fibre Channel Interface
Module (Eight Ports)/16 Gbit/s Fibre Channel Interface
Module (Eight Ports)
This section explains how to replace an 8 Gbit/s Fibre Channel interface module
(eight ports). The parts replacement method of a 16 Gbit/s Fibre Channel
Issue 15 (2019-12-30)
NO TICE
Figure 7-82
If the indicator is steady green, the interface module has been successfully
installed.
If the indicator is steady red or off, the newly installed interface module is
faulty, the interface module slot is faulty, or the interface module is
incorrectly installed.
Perform a post-replacement inspection.
After the parts replacement, return to the SmartKit page and click Replaced.
Then complete the parts check after the replacement as prompted.
Check system status.
On the Parts Replacement page, click Inspection to check the system status
again. If any item fails inspection, rectify the fault based on the suggestions in
the inspection report.
After the preceding procedure is complete, check services on the host for
storage-related errors.
Copyright © Huawei Technologies Co., Ltd.
shows the location of the Power indicator.
7 Replacing FRUs
229