Huawei OceanStor V5 Series Parts Replacement page 184

OceanStor V5 Series
Parts Replacement
●
●
●
Procedure
Step 1 Check status before replacement.
1.
2.
You can proceed to next steps only when all items pass the pre-replacement check
and the replacement page is displayed. If any item fails, rectify the fault as
prompted.
Step 2 Wear an ESD wrist strap and remove all the cables from the system subrack that
you want to replace.
Step 3 Take the spare part out of its ESD bag and place it on the ESD table.
Step 4 Insert the product model bar into the upper part of the spare part. The arrow in
Figure 7-39
Issue 15 (2019-12-30)
Nameplate
Intel label
Device information label
Check system status.
Start SmartKit and choose Home > Storage > Routine Maintenance >
Health Check. On the Health Check page, perform inspection as instructed.
For details, see 7.1.2 Checking System
If any items fail the inspection, rectify the faults by performing the recommended
actions in the inspection reports. Ensure that all other parts except the parts to be
replaced are working properly.
Check the status of the parts to be replaced.
Start SmartKit and choose Home > Storage > Parts Replacement > Parts
Replacement. On the Parts Replacement page, click FRU Replacement.
Then complete the check before the replacement as prompted. For details, see
7.1.3 Replacing an
NO TICE
shows the installation position of the product model bar.
Copyright © Huawei Technologies Co., Ltd.
Status.
FRU.
7 Replacing FRUs
175