Huawei OceanStor V5 Series Parts Replacement page 244

OceanStor V5 Series
Parts Replacement
Figure 7-87 Power indicator/Hot Swap button on an 8 Gbit/s Fibre Channel
interface module (eight ports)
Step 11 When the Power indicator becomes steady green, install the optical module.
Take the dustproof cap off the optical module, hold the rubber handle outside the
optical module, and insert the optical module into the port, as shown in
7-88.
● Push the optical module to the end. If you hear the click or feel a weak
● If an optical module is installed incorrectly, it will be loose or cause a link
Figure 7-88 Installing an optical module
Step 12 Connect cables.
The cable should be connected to the new 8 Gbit/s Fibre Channel interface
module (eight ports) at the same position as to the old one to ensure proper
service running.
Issue 15 (2019-12-30)
NO TICE
vibration, the optical module has been successfully installed.
interruption.
NO TICE
After the 8 Gbit/s Fibre Channel interface module (eight ports) is installed, wait 4 minutes
before connecting the cables so that the status of the new module can be updated.
Copyright © Huawei Technologies Co., Ltd.
7 Replacing FRUs
Figure
235